Notches can be added to any Rod-Pocketed edge, allowing for additional support where it is notched.  EEFX.COM recommends a third support (one in the center) for spans of 15 feet or longer. Long crossbars have a tendency to sag if they are not supported in the center. This can cause rippling and shadowing problems. Notches allow you to add additional support which insures your backdrop hangs straight. Two notch options are available.  Rod-pocket notches must be purchased in conjunction with an EEFX.COM chroma key backdrop and a rod-pocket.


Notch Options:

(Click to Enlarge)	Full Access Notch  - 4" wide Notch that extends almost the full height of the pocket (roughly 3.5" x4"), allowing access to the underside of the crossbar. Perfect when combined with EEFX's center support hardware (call or email to order).
(Click to Enlarge)	1/2 Access Notch  - 3" wide Notch that extends only 1/2 the height of the pocket (roughly 3" wide x 2" tall round notch). This option works best when rope, ties, or straps are used to pull the crossbar up in the center. The 1/2 notch gives you more green screen cover at every notch location.

NOTE: Mounting hardware is sold separately. Notches are placed evenly across the rod-pocket. (IE: If you order a single notch on a 15' pocket, it will be centered at 7.5'. Notches cannot be placed across a seam.  If you order a notch that falls on the center of a seam, your notch will be placed slightly off-set next to the seam.)